Enfield Precision Decat Pipe, Stainless Steel - Bear 650

UK MADE DECAT PIPE, STAINLESS STEEL, BRUSHED FINISH, 650 Bear

Manufactured in the UK from T304 stainless steel, this decat pipe is manufactured specifically to suit the Royal Enfield 650 Bear model. It is not mass produced, and each pipe is made with care and attention by our dedicated fabricators using high quality materials.

The original collector box is of a considerable size and weight and adds a large restriction within the exhaust system. This decat pipe bypasses the whole collector box and allows the bulky and heavy section to be completely removed from the bike. This gives an improvement in both performance and noise output, giving a deeper, healthier exhaust sound.

Our decat pipe includes a provision for the oxygen sensor to ensure compatibility with Euro 5+ models, as well as a stainless blanking plug for Euro 5 models that do not use the third O2 sensor. The mounting bracket replicates the original Royal Enfield design with an adjustable rubber mount to help absorb vibration and give a good fit. The end fitting is swaged to the correct size as standard, this helps to remain compatible with both the factory silencer and aftermarket silencers.

As with the original Royal Enfield setup, this decat section retains the graphite seals at either end of the pipe. These not only provide a secure seal but also help to dampen vibration and reduce strain across the entire exhaust system. The original seals can often be reused, but if replacements are required, they can be ordered separately from the related items below.

Includes a replacement clamp; however, you may wish to purchase new seals and a rubber bush if you prefer not to reuse your original parts (see related items below).
As with all stainless steel exhausts, as they go through heat cycles there will be a change in colour, particularly around the header area. 

IMPORTANT: Sold for off road use only.